I really hope that you change the manual run portion of the Netro App back to the way it was. As a dealer, installer, and owner, I find the changes made earlier this year make for a very time-consuming, difficult, and glitchy experience. To schedule a runtime of more than 1 minute is a pain and usually the timer is unresponsive.

For my whisper, what is k lic sunlight?  I googled it and it’s intensity. Like direct sun has higher lux  than overcast

I can’t tell from the app how much hours of good sunlight there was each day last week

If I use a water retention system like Hydretain, how do I set the app to take this into consideration? Since we would need to water much less.

My Nest App is showing that some of the Zones are not running when they’re scheduled to run. For today, none of them are running. Please help! 

I live in Houston.   We're having a month long heat water and our city has been raising water rates and they are now some of the country's highest.   Anticipating $1000+ next month for 10K sq ft yard.   Lawn very green with Netro (fully automatic).    How can I sacrifice some of my plush green so I can afford to buy gas?

Hi!

Where I can enable the master valve? I need to connect to master valve the water. 

Thanks 

Hi!

How do I turn off the SMART SCHEDULE?

Thank's

I decided to skip all zones after the program started running since I am working in the yard today.  Three zones have run, but I want to skip the rest so it is not so wet. I get the following error. 

Netro app says we received rain yesterday but it didn’t rain at all.  When I go to correct in app it only allows me to go as low as .1 inch.  How do I adjust to zero?

I would LOVE to have a way to move a days scheduled run (and all subsequent runs) ahead XX days.  For example, if I have all my zones scheduled to run tomorrow, but it is raining today (and I'm scheduled for every third day runs), it would be great to move tomorrow's run ahead 2 days (as maybe it's not raining TOO hard, but enough to warrant not watering tomorrow), and then that move trigger all subsequent runs to move ahead by that many days as well.  Any plans for such a feature?

My rain delay is set to 15 days. How do I reset or delete the current delay?

The program is now scheduled 15 days out, and I have disabled and re-enabled my program in hopes it would reset it. I checked restrictions and the delay is not listed.

Thanks!

Trying to add ISANREMO24 to PWS but I always get this error:

Please enter a valid ID !

Can you fix the problem or add for me:

ISANREMO24

I just installed the pixie timer and i would like to test it. 

However even if i scheduled two test runs, none of them appears in the schedule yet.  Is the schedule updated only once a day? 

Manual run is not available (the timer appears strike-out) so i cannot even test that way.

Thanks in advance for your help

Best 

 Jacopo

Hello,

I am using one Netro Pixie Hose timer to water 2 freestanding planters via a hose splitter.  I am looking for a way to add 2 Whisperers to the Netro App to monitor both planters for watering needs.  The app appears to only allow one per zone.  Is it possible to add a second Whisperer to the same zone?  I am not concerned about overwatering as the planters allow for extra water to drain out easily.   I just want to make sure neither planter dries out.

Thanks

Vorrei usare un altra app meteo come si può collegare 

Hi there,

Is there an option to set a manual run or a one time run for more than 60 minutes? I would like to perform a deep soak on some of my older trees. The smart schedules will only run water less than an hour as well. Is there an explanation why zones will not run for more than an hour? 

Thanks

I used to be able to start any zone I wanted from the Home Screen by hitting a big green arrow. Where did it go? This was very handy for cycling through zones at system startup and shut down in the fall. Now how do I do it?

Buenas tardes,

Que es más eficiente poner en lluvia en la aplicacion:

Pronóstico o expectativas.

y en umbral (milímetros), que cantidad debo poner.

Gracias

Anyway to set home as the default instead of plant sensors when the app opens?

Hi,

I have some trusted meteo station in my city, I've tried to add them via WU but the netro app reads wrong maximum and minimum temps. In WU all data is fine. Can you patch the problem?

Thanks