Tech support

I've been playing with my Netro controller for 6 hours now. I create programs and the first time when I look at the schedule the zones are not shown in order and then they repeat for a second time with a different intervals after the first run ends. I try cancelling the duplicates and both occurrences disappear. I could not figure how remove the duplicates only so I tried resetting the controller. I took about 5 tries before it worked.  Then I did the wifi setup and setup a new program. Just a basic 11 zones with a start at 6:00, weekly and start on jun 16,2022,and I enable it and save. When I check the schedule. Nothing shows up for 6/16 and on the home screen it says next run not scheduled.  All of the 11 zones say next in -- without any entry.


回复来自 Wency Pan

19
Wency Pan
 更新时间 2022-06-14 06:38:55 UTC

Hi Robert,


Some zones are watered multiple times a day, you probably selected clay, clay loam or loam as the soil type which accepts water slowly, often as little as 1/4 inch per hour and that is why we break the watering into many pieces to avoid water runoff.

If you think the smart schedules water too much , you can either change to different smart zone mode (ECO), or you can set up your own programs and set up your smart zone in basic level. Please check this article for more info. https://netrohome.com/forum/posts/111 


If you see "next run not scheduled", you controller is in standby mode and please tap the "enable" button to enable your device in the home page. 


Thanks,

Wency

Netro Support

浏览: 1360    点赞: 0