User profile photo

Ken Laberteaux

居住在: Ann Arbor, MI, US
使用: SPRITE-6

問題

Default Smart Zone settings

21
Ken Laberteaux
更新時間 2021-09-17 00:51:11 UTC
話題: 智能庭院

Each Smart Zone can be set to a preset, e.g. Frequent, Deep, Boost, EPA, etc.  If you click Customized, you can choose the Min and Max Soil Moisture, and the Flow Rate (inches/hour).  Presumably, there is a default value of these three choices for each of the presets.

How can I find out what the presets are for these three values?  e.g. for the EPA preset, what is the Min, Max, and Flow Rate?  Same question for all of the Smart Zone presets.

Thanks!

Ken

Fine-tuning smart watering for rotors

21
Ken Laberteaux
更新時間 2021-06-22 04:16:23 UTC
話題: 智能灌溉

I have a smart zone comprising rotor heads.  As I understand, rotor heads need to be run for longer times than other types of heads because they are only delivering water to one direction at a time (the current direction of the stream of water from the rotor).  Further, the amount of water delivered in a given time depends on how large of an arc the rotor passes through.  For example, if the rotor sweeps through only 180 degrees for 10 minutes, that ground gets 2x the water per unit area than if it runs through 360 degrees for the same 10 min.


So, it seems that, since the choice of rotor head does not include information about the arc it will travel through, there is no way for the smart watering algorithm to know how much water is being delivered per unit area, i.e. a zone with rotors going all 360 degrees is likely under-watering.


I believe this is happening on my lawn, and i would like to make a change in order to increase the time of watering for this zone.


What dials do I have at my disposal to make the smart watering algorithm water this zone for a longer period of time?

Water turned off

21
Ken Laberteaux
更新時間 2020-07-31 01:08:39 UTC
話題: 智能灌溉

I had to turn off my water valve to my sprinkler system for a week (ending in a few days) and forgot to disable smart watering on my netro.  Netro thinks it did a complete watering last Saturday, and adjusted estimated soil moisture accordingly.  Netro isn't planning another watering for another 9-10 days.  However no watering last Saturday occurred.  


How best should I handle this?  Is there a way to delete past watering, which will lower soil estimated moisture, triggering a sooner watering than currently scheduled?  Or should I just do a manual long watering as soon as I can?