User profile photo

C He

居住在: Dohna, Sachsen, DE
使用: SPARK-8 , WHISPERER-2

問題

Parallel Run of watering

10
C He
更新時間 2023-09-08 08:39:13 UTC
話題: 智能灌溉

Hallo and short question: 


I can not find any option to water more than one zone in the same time. Ist this not possible? 


@Netro team: in case the feature is not available at the moment i would appreciate your development 

Watering by moisture level higher 90%

10
C He
更新時間 2023-09-04 06:22:44 UTC
話題: 智能灌溉

Hi, 


Netro will water my garten when the Whisperer sensors show 92% moisture level. 


This is smart watering? 


I think, there is no water needed or I’m wrong?




Ventiles are not closed from spark - not smart watering

10
C He
更新時間 2023-08-17 05:23:52 UTC
話題: 智能灌溉

Hello Netro Support, 


The Spark startet watering today at 4 am as it was calculated by whisperer and weather. 3 Zones got water, but instead of watering 10 minutes the gras got 3 hours water. 

I wasted a lot of water, this is far away of smart watering. My old installation from Gardena / Husquarna never had such problem. 


The spark was not able to close the Ventils! 


The only way was the make the spark powerless. 


What’s wrong? 


Again: the test procedure of the ventiles works without any problem, spark open AND CLOSE every ventile step by step! 



 

Ventile open, but not closed, Ventilttest successfully done

10
C He
更新時間 2023-08-13 11:54:36 UTC
話題: 智能庭院

Hello, 

Problem: Ventiles open by Netro successfully (by schedule or manually. But after the run time the Ventiles do not close. The only option i have is the switch off the Netro. Than the ventiles close. 


Ventilttest successfully done (see screenshot)


Whats wrong? 


Spark and Sensors

10
C He
更新時間 2023-08-10 06:45:57 UTC
話題: Netro App

Hi all,

I use 1 Netro Spark with 2 Whisperer sensors.

All devices are added to the app and i can see in the app.


In the app I can open by dropdown on top the Spark OR the Sensors. When i open there the Spark and go to setup, then i can can see the entry sensor, but the i can not add the sensors i have. 


I want to connect the sensors to the spark and the spark should Start the watering in relation to the real condition measured from the sensors. 


But how to connect the Whisperer to the Zones? 


Thanks for support!