User profile photo

Netro Customer

居住在: Las Rozas de Madrid, Comunidad de Madrid, ES
使用: SPRITE-12
增長: Lavender Plant, Virginia Creeper

話題

問題

Problem with irrigation time
33
Daniel Encinas
更新時間 2024-07-12 10:43:36 UTC
話題: 故障排除
Hello, I have owned a Netro Sprite programmer for several years.

The problem I have is that it programs the phases intelligently and if it indicates that it has to water for 10 minutes. It only waters for about 1 minute but the app shows that it has watered for 10 minutes. The garden is drying out and I don't know what to do.
This happens to me in all irrigation phases. If I program it manually the same thing happens to me. If I try it twice, the second time it takes even less time to water.
I have connected the transformer directly to the phase, bypassing the programmer, and it works correctly.
Reviewing its problems section, I found a similar one in which it says to look at the 24 volt voltage. (which is correct, around 30 volt) and the resistance in ohms of more than 20 (around 30 ohmios). It also says that there the programmer has a recoverable fuse.

What can I do?


Thanks

The app indicates that it waters and does not do it in reality
33
Daniel Encinas
更新時間 2021-08-18 06:17:45 UTC
話題: 故障排除 
Hi all,

My problem is that in the app it appears that it is watering each area and the reality is that it either does not water at all or water less time. I have been on vacation for a few days and I have found the dry grass and two trees without leaves. A disaster. I have been communicating with the support service by email for several days and I do not have a clear answer to this problem. Can anybody help me?

Thanks a lot,

Daniel